Datsun Roadster Forum-311s.org

Looks good as long as the engine is at TDC with #1 cylinder on the compression stroke

My car has a wide variety of non-matching lugs. What is the correct style?

Are the heads on an R16 3 main an 5 main the same?
And will both accept an H20 block?
Thanks

AidanDawn2000 wrote:trying again, Anyone have a good source for mostly original looking HW wiper blades? Anyone tried this one?
https://www.amazon.com/dp/B000CB2MIU/re

The part numbers in the wiki seem to all be out of production :/

I just ordered these ANCO 20-13 Vintage blades. They're an inch longer than the Tricos. I'll report back on fitment.

Look at this on eBay http://www.ebay.com/itm/253048379826

Dustin82 wrote:

AidanDawn2000 wrote:trying again, Anyone have a good source for mostly original looking HW wiper blades? Anyone tried this one?
https://www.amazon.com/dp/B000CB2MIU/re

The part numbers in the wiki seem to all be out of production :/

I just ordered these ANCO 20-13 Vintage blades. They're an inch longer than the Tricos. I'll report back on fitment.

Look at this on eBay http://www.ebay.com/itm/253048379826

For AidanDawn2000,

I got to put these on and they fit/look great.

Can't you just keep the original holder and just slide the rubber wiper in there. I think you can even trim a wiper that is too long.
Linda

That's what I would do if the ones I were replacing weren't black. Now that the hardware is OE looking, I'll go with the rubber inserts moving forward.

Dustin82 wrote:That's what I would do if the ones I were replacing weren't black. Now that the hardware is OE looking, I'll go with the rubber inserts moving forward.

Thanks! those look great...i'll order some up rn.

how does one tell the difference between the left and right side rear round side marker lights please? Thanks

Simon,
Some wheels, like Appliance take special lug nuts, so depends on your wheel .Z wheels use different studs. Larger wheels need longer studs frequently too. A pic would be best.
Linda

tjp wrote:how does one tell the difference between the left and right side rear round side marker lights please? Thanks

R or L on the bottom of the rubber bits.

Linda wrote:Simon,
Some wheels, like Appliance take special lug nuts, so depends on your wheel .Z wheels use different studs. Larger wheels need longer studs frequently too. A pic would be best.
Linda

I'll get some pics and post em...

In other news, it seems like every time I pop the hood, my clutch reservoir cap is slightly off.

Anyone know if this is normal and how I can prevent this ?
I should probably change that fluid, right?

Yes, I would change the fluid! May preserve the seals a little longer.

haha Yea thats the easy question! How about the fact that the cap keeps popping off?

Cap should have an atmospheric vent in it somewhere: maybe it's blocked?