Page 2 of 2
Re: Alternate replacement front hub dust caps
Posted: Sun Aug 02, 2020 7:15 pm
by Linda
Maybe if you put a slit in the cap where it enters the housing it would fit? OP said it was not tapered so it was tight.
Linda
Re: Alternate replacement front hub dust caps
Posted: Sun Aug 02, 2020 7:20 pm
by MattC
No, the OP was talking about the Avonride ones, which are on Amazon now for about $38 for 4 of them. I might go that route if I can't fix the original one. The NAPA ones hit solidly on the outer edge of the hub and I feel like you'd probably destroy them (or the hub) trying to get them in.
Re: Alternate replacement front hub dust caps
Posted: Thu Aug 20, 2020 4:37 pm
by Linda
So I lost a dust cap recently. Wanted something quick so got an Autozone dust cap, Dorman 13996, with a 1.81 OD diameter to fit in to my measured 1.85 hub. The cap slid in like I thought so I bent out the lip of the cap at 4 points around the edge so that it would tap in. Plan to use a tiny bit of blue Loctite and then see how it all works.
Not as nice as stock but OK. Doing the other side as well.
12AFAFA1-417C-4357-B3B6-C0236D463938.jpeg
Linda