ATTACHING EMBLEMS

Scott Smith · Post by **Scott Smith** » Sun Nov 14, 2004 1:38 pm

Does anybody have a good idea for attaching the emblems to the car. Looking for a fastner other than the metal push on clips??
thanks

Post by **itsa68** » Sun Nov 14, 2004 4:57 pm

You might want to check out the sheet metal speed nuts that some auto body shops offer.

Here is an example link.
http://www.thefastenerwarehouse.shoppin ... 568857.htm

Ray B.

DELETED · Post by **DELETED** » Sun Nov 14, 2004 4:58 pm

DELETED

JoeK · Post by **JoeK** » Sun Nov 14, 2004 11:22 pm

All the emblems on my car were held on with a dab of caulking. I think they probably taped the emblems in place and put a dab of caulking around the tab, from the inside. Didn't look great from the inside, but it seemed to hold well and was probably a very cheap solution. It made it pretty easy to remove as well.

I will most likely re-install with screw on type fasteners like those Ray linked to.

Good Luck,
Joe

Scott Smith · Post by **Scott Smith** » Mon Nov 15, 2004 11:57 am

Thanks for the info. I will probably try all these ideas just for fun.
I did find speed nuts and they look like they will do the trick.
thanks again