Can anyone confirm if the Z caliper inlet fitting thread is 10mm x 1.0 inverted flare?
I believe I need some adapters and new lines to make my Z caliper conversion work.
Z caliper inlet fitting thread
Moderators: notoptoy, S Allen, Solex68
-
gpdatsun
- Roadster Fanatic
- Posts: 145
- Joined: Sat Mar 22, 2008 11:52 am
- Location: Madison, WI
Z caliper inlet fitting thread
Bill Wessel
68 1600
FP/GP 1600
garage-full of roadster stuff
68 1600
FP/GP 1600
garage-full of roadster stuff
-
gpdatsun
- Roadster Fanatic
- Posts: 145
- Joined: Sat Mar 22, 2008 11:52 am
- Location: Madison, WI
Re: Z caliper inlet fitting thread
I got both 3/8 x 24 IFM and 10mm x 1.0 IFM....looks like it's metric thread...not even the S30 shop manual download could tell me.
Bill Wessel
68 1600
FP/GP 1600
garage-full of roadster stuff
68 1600
FP/GP 1600
garage-full of roadster stuff
-
spl310
- Roadster Guru
- Posts: 13241
- Joined: Sun Dec 29, 2002 10:38 pm
- Location: In front of this keyboard... in Jacksonville, Florida!
Re: Z caliper inlet fitting thread
I would have suspected Metric, but did not know for sure and had no source to check. If I had known for certain, I would have piped up.
"Wow, a Roadster!" Stuart Little
1967.5 2000
1967.5 2000
1964 1500
1964 1500
1967.5 1600
1968 chassis
2006 Acura MDX
2013 Volkswagen Jetta TDI wagon
1995 F350 Powerstroke!
More...
1967.5 2000
1967.5 2000
1964 1500
1964 1500
1967.5 1600
1968 chassis
2006 Acura MDX
2013 Volkswagen Jetta TDI wagon
1995 F350 Powerstroke!
More...