Parting out three '69 roadsters

[S Allen]

Parting out three '69 roadsters. 2 2 liters and 1 1600. A few of the parts are already spoken for but let me know what you are looking for and I will see what we can do. One of the 2 liters was fire damaged and am only getting suspension bits and a 3.7 rear end. Body was pretty much toast and has already been cut up. Getting ready to cut the frame up so if you need a frame bit let me know right away. An example would be sway bar towers. Thanks.

Steve

[spriso]

Sway bar towers, frame "saddles" (where the frame transitions from the X to the front suspension) and traction bar brackets could be harvested from the frame!

[S Allen]

I will go ahead and cut those out so they will be reusable. Thought about the sway bar towers as I have seen a few bent ones of those. Thanks.

Steve

[mwegener111]

I'd be interested in a set of front side markers if they are available

[S Allen]

One set of the front tear drops is all I have. The others are pretty much toast. The lenses are not great and I snapped two of the mounting pins off while removing them. They could be drilled out to put a pin in or a fastener. I can send you the details and pics via PM if you want. Thanks.

Steve

[mwegener111]

One set of the front tear drops is all I have. The others are pretty much toast. The lenses are not great and I snapped two of the mounting pins off while removing them. They could be drilled out to put a pin in or a fastener. I can send you the details and pics via PM if you want. Thanks.

Steve

Thanks Steve, it's really the lenses I am looking for. I bought new bodies on Yahoo Japan for $25.00 each. The good lenses are so very hard to find.
Thanks for the reply, and I'll just have to keep looking.

Thank you.

[S Allen]

Np's

S

[TNlizard]

I need a good set of tail light housings. I have the lenses and outer rings. Also need the straight Chrome strips on the front fenders and a console lid.

[S Allen]

Sorry. no tail light housings.

S

[mikeb]

Steve,
I'd be interested in the torque rod bracket that is welded to the frame if it can be removed cleanly. I have a 67.5 and I assume they're the same.
Thanks,
Mike

[S Allen]

Mike,

Sorry, there was no easy way to get the bracket off cleanly wihtout a plasma cutter. I have the torque rods but no brackets.

Steve

[mikeb]

Steve,
Thanks, I appreciate the response....they definitely don't look easy to remove. Mine actually separated and is in two pieces. But I know a good welder/fabricator and will see what he can do with it.

Thanks again,
Mike

[super-bee_ski]

Hi!
Im looking for a rear Tail Panel....
Mark from Edwards AFB, So Cal....

[William]

Any dashes available for the 69's?

William

[JT68]

Hi Steve, we can always use the lower front a-arm triangles spring seat. (L&R). 1600 or 2000 are the same. Any year is fine.thx, jt