I am getting a leak at the speed cable / housing so am trying to check the seals. I did this before in w 2012 but I guess the seals go bad after some time. Anyway I can ‘t seem to get the 90 deg housing off, it rotates but should it be levered off? The keeper bolt and tab are off. Also looks to be very close to the frame, car is jacked up on left side, if that could be an issue.
Should tranny be in neutral for more rotation or not?
Can’t remember how it all was done previously lol
Thx
Linda
Speedo 90 deg housing removal
Moderators: notoptoy, S Allen, Solex68
-
Linda
- Fraternal Den Mother-RIP
- Posts: 7807
- Joined: Sat Nov 05, 2005 11:37 pm
- Location: Los Angeles
- Model: 1500/1600
- Year: High Windshield-68-70
Speedo 90 deg housing removal
Last edited by Linda on Fri Sep 25, 2020 4:28 pm, edited 1 time in total.
Sadly-Linda has passed away 2022. She was the 311's den mother and drove the first Rare-Parts ball joint project. RIP.
-
Linda
- Fraternal Den Mother-RIP
- Posts: 7807
- Joined: Sat Nov 05, 2005 11:37 pm
- Location: Los Angeles
- Model: 1500/1600
- Year: High Windshield-68-70
Re: Speedo 90 deg housing removal
OK got the 90 deg out by undoing the big nut with channel lock pliers. Should have known to do that for those following along 
So small seal goes in this pic, letters facing out on the pinion gear itself inside the tranny after pulling it out?
Looks like the pinion
Linda
So small seal goes in this pic, letters facing out on the pinion gear itself inside the tranny after pulling it out?
Looks like the pinion
Linda
You do not have the required permissions to view the files attached to this post.
Sadly-Linda has passed away 2022. She was the 311's den mother and drove the first Rare-Parts ball joint project. RIP.