Cool Airdams Now Available

[spl310]

Thanks JT!

[Alvin]

How do they match up with the wheel wells?

They fit exactly like the ducted airdams sold for the last few decades, since it is an exact copy of those.

JT, thanks for making these!
For dummies like me, to address Sid's question about fender edge fitment does your airdam look like this:



or this:



Or neither?

[JT68]

You are welcome Alvin. Probably most like the NOS car version depending.

You could probably get the look of the 2nd white car if you mounted it as far forward as possible and trimmed it like that, but it comes nearly all the way back to where the fender starts to bend away from horizontal. If you are trying to blend into the flare curve transition exactly, a body guy would probably need to do that. How you will trim it out also probably depends on how virginal your lower fender valence is too.

Here it is mocked up on a friend's car. Sorry for the contrast, but you get the idea. You can see where the mounting surface will need to be sanded back/trimmed if trying to match the fender line exactly for street.

Again, this is simply a copy of the classic design with the extended lower valence. If you trim away the lower section, it looks pretty much identical to the others.

[mshort07]

That must almost scrape the ground!

[JT68]

Yep, we left it full length as designed for track cars. Trim just below the brake duct for the typical street look and to avoid speed breaks. Depending on how low the car is you could leave a bit below the ducts as shown in the two white cars shown above. Pretty universal.

[Alvin]

Thanks for the clarification JT! So basically what I'm seeing is folks trimming these differently. Pretty cool that you are offering these!

[JT68]

The initial run of air dams is sold out. Thank you to everyone who voiced interest and purchased!

Intro price extended through June. We'll have 8 more. PM or email to grab one at the low price.

Best,
Jt
DatsunRestorationProducts.com

[Mackn367]

Thanks again for all your hard work on this JT! I'm sure it's no easy task to get these produced.

[RC240z]

so now these are available two places. Classic Datsun has sold these for years and now a new vendor...

[Mackn367]

I got one of JT's (aka Datsun Restoration Products)

It's great! I haven't installed it yet but it has been painted. I think I will have to shave/cut some of the bottom part still since I think it will be too low to the ground and constantly scrape on these CA curbs.

Oh and it is technically upside down on the table.

IMG_1722.jpg

IMG_1813.jpg

IMG_1814.jpg

[theunz]

Upside down.

[Mackn367]

Upside down.

Yup that's what I said (wrote it right above the picture )

[theunz]

Opps, looks like I'm dyslexic! Transposed the it and is

[TedDibiasejunior]

Any more in production? If so what is the cost?

[JT68]

We do have a few left in stock. They are 265. We'll add them to the webpage. PM or email for purchasing.

Nice work by the installers shown above!