Stock wheel centers on 15" wheel?

[GoldHawg]

Picked up a set of 200SX wheels yesterday for $40 locally; rough (rusty and all the tires have dry rot) but worth $40 just to see if something might be done. Looks like there is the ~30mm room on the wheel to go inboard with the center if one cuts it out and rewelds. Would still have to have a clip welded on to hold the center cap.

[Pjackb]

40$ is cheap
Looking at the pictures it would definitely look better if they were re welded
looking forward to see the results if you do it

[Pjackb]

did you ever end up doing anything with this ?

Also would it be possible for you to take the measurement of the ID at the center of the wheel ( the distance between the 2 arrows )
Thanks

InkedIMG_1547_LI.jpg

[GoldHawg]

Nothing yet; they're stored for a potential "one day". Trying to get my current build done and I'm way behind. Best I can measure is between 13 3/16 and 13 1/4. See pic.

[Pjackb]

Thanks
It answers 2 of my questions
1-Stock wheel centers will not fit
2- there’s plenty of room should one want to have the centers moved in to change the offset , based on this picture there’s more than 1 1/4 inch of play moving them 1inch would make the offset about +15 which is perfect with a 6inch wheel