Maybe we can gather info in one spot because I can't find anything in archives or Wiki.
Anyone done this? I know you need the smog bracket, got that. Any mods on it needed?
Which adjusting bracket, does stock work?
Does the stock triangle work?
Long bolt for lower mount seems to be M10 or 3/8-16. Any other choices?
Shorter belt was mentioned, any part no on the V belt?
Any pics appreciated.
Thx
Linda
Justy alternator on R side of R16 engine
Moderators: notoptoy, S Allen, Solex68
- Linda
- Fraternal Den Mother-RIP
- Posts: 7807
- Joined: Sat Nov 05, 2005 11:37 pm
- Location: Los Angeles
- Model: 1500/1600
- Year: High Windshield-68-70
Justy alternator on R side of R16 engine
Sadly-Linda has passed away 2022. She was the 311's den mother and drove the first Rare-Parts ball joint project. RIP.
-
- Roadster Fanatic-Site Supporter
- Posts: 1790
- Joined: Sat Nov 21, 2009 11:37 pm
- Location: Vancouver, Washington
- Model: 1500/1600
- Year: High Windshield-68-70
Re: Justy alternator on R side of R16 engine
I haven't seen much a out the Justy alty on other than SR20.
I think much will depend on your setup. I'd start with the factory alty mount and triangle. Set the alty in l
Place and eyeball for belt alignment.
At that point you can approximate spacer sizing and get within a washer or two of aligning the belt.
I drilled my mount to take a 10mm bolt and used the factory tensioning arm on the 2000 with Denso.
My cars both have the wa spacer removed and use electric fand so may not represent you setup.
Dan
I think much will depend on your setup. I'd start with the factory alty mount and triangle. Set the alty in l
Place and eyeball for belt alignment.
At that point you can approximate spacer sizing and get within a washer or two of aligning the belt.
I drilled my mount to take a 10mm bolt and used the factory tensioning arm on the 2000 with Denso.
My cars both have the wa spacer removed and use electric fand so may not represent you setup.
Dan
SPL311 aka Skooter. Sold. Now wasting away in the SF area.
1990 Nissan 300zx. Sold this one too.
2018 VW Tiguan
1990 Nissan 300zx. Sold this one too.
2018 VW Tiguan
- Linda
- Fraternal Den Mother-RIP
- Posts: 7807
- Joined: Sat Nov 05, 2005 11:37 pm
- Location: Los Angeles
- Model: 1500/1600
- Year: High Windshield-68-70
Re: Justy alternator on R side of R16 engine
Good info in that the 10 mm bolt seemed to fit better when I checked, but not as many choices for length...but maybe I won't need it. Can you guess on the approx length of bolt ultimately used?
On triangle, a pic of that if possible, so I know where to start with initial alignment.
Thx
Linda
On triangle, a pic of that if possible, so I know where to start with initial alignment.
Thx
Linda
Sadly-Linda has passed away 2022. She was the 311's den mother and drove the first Rare-Parts ball joint project. RIP.
- redroadster
- Roadsteraholic
- Posts: 2435
- Joined: Tue Mar 12, 2013 10:58 am
- Location: KCMO
- Model: 1500/1600
- Year: High Windshield-68-70
Re: Justy alternator on R side of R16 engine
Just thought I would say I worked at Volvo in the late 80s
85 and up 240s'740s. alternators had a brush pack unit with the regulator built in that was small . it was a 2min. Swap out the back
One of those alt. Could be adapted to a 311 or the brush pack installed on a datsun alt with a bit of machining
https://www.rockauto.com/en/catalog/vol ... lator,4884
85 and up 240s'740s. alternators had a brush pack unit with the regulator built in that was small . it was a 2min. Swap out the back
One of those alt. Could be adapted to a 311 or the brush pack installed on a datsun alt with a bit of machining
https://www.rockauto.com/en/catalog/vol ... lator,4884
Datsun dealer tech 76 to 87
Mitsubishi tech 9 yrs
Volvo, Kia, Toyota too
6 month - Rolls Royce
ASE MASTER TECH 96. - 11
70 SPL 86 Z31 T , Sportster
Mitsubishi tech 9 yrs
Volvo, Kia, Toyota too
6 month - Rolls Royce
ASE MASTER TECH 96. - 11
70 SPL 86 Z31 T , Sportster
- Solex68
- Site Supporter
- Posts: 2097
- Joined: Fri May 25, 2012 3:30 pm
- Location: Laguna Hills, CA
- Model: 2000
- Year: High Windshield-68-70
- Contact:
Re: Justy alternator on R side of R16 engine
Linda,
Be sure to remove the original voltage regulator under the hood.
Be sure to remove the original voltage regulator under the hood.
You do not have the required permissions to view the files attached to this post.
Greg a.k.a SOLEX68 - http://www.datsunvents.com/
Laguna Hills, CA
68 2000
Always willing to help another Datsun Roadster owner
Pending installs: All steering components, Stan Stealth Dizzy
Laguna Hills, CA
68 2000
Always willing to help another Datsun Roadster owner
Pending installs: All steering components, Stan Stealth Dizzy
-
- Roadster Fanatic-Site Supporter
- Posts: 1790
- Joined: Sat Nov 21, 2009 11:37 pm
- Location: Vancouver, Washington
- Model: 1500/1600
- Year: High Windshield-68-70
Re: Justy alternator on R side of R16 engine
I'm pretty picture challenged Linda. Between my Pixel phone and Samsung tablet I struggle to post pictures. I'm at the coast fow a few days but will give it a try later this week.
Dan
Dan
SPL311 aka Skooter. Sold. Now wasting away in the SF area.
1990 Nissan 300zx. Sold this one too.
2018 VW Tiguan
1990 Nissan 300zx. Sold this one too.
2018 VW Tiguan
- Linda
- Fraternal Den Mother-RIP
- Posts: 7807
- Joined: Sat Nov 05, 2005 11:37 pm
- Location: Los Angeles
- Model: 1500/1600
- Year: High Windshield-68-70
Re: Justy alternator on R side of R16 engine
Gonna stick to this alt at this point. No Z, GM or anything else,but good info. Focused only on this as everything takes too long as it is with my car and me.
I have the alt, plug, now figuring out HOW.
Planning on no ext VR , Greg, since it is IR but not there yet.
Linda
I have the alt, plug, now figuring out HOW.
Planning on no ext VR , Greg, since it is IR but not there yet.
Linda
Sadly-Linda has passed away 2022. She was the 311's den mother and drove the first Rare-Parts ball joint project. RIP.
- Linda
- Fraternal Den Mother-RIP
- Posts: 7807
- Joined: Sat Nov 05, 2005 11:37 pm
- Location: Los Angeles
- Model: 1500/1600
- Year: High Windshield-68-70
Re: Justy alternator on R side of R16 engine
Bump
Sadly-Linda has passed away 2022. She was the 311's den mother and drove the first Rare-Parts ball joint project. RIP.