Mikuni throttle linkage setup

[DatsunNissanFan]

Hi,
I sort of put together my Mikuni setup with a manifold/linkage setup meant for 510s with the L style throttle cable linkage. I had to pull that off, then tapped the hole that was there on the rod to place my throttle cable clamp from my previous SU carb linkage. Then, the cable stop had to be again tapped into the manifold center area where it was solid and secured...I couldn’t find a set of manifold meant for this. Anyone know where to get a manifold with the throttle linkage setup meant for our cars? I think this will work fine too but I’m a bit OCD about it. Any comments or inputs would be appreciated!

[Nissanman]

It is CDO not OCD.
The letters are in alphabetical order LIKE THEY SHOULD BE

[fj20spl311]

That's a 510 motor.
Not very likely you will find a manifold / linkage for a roadster.
Looks like you did a fine job.