After Linda proposed pin repair to the "D", I thought, why not the stainless trim clips.
Grabbed a few 8/32 pan head screws from the junk drawer and went after it.
Ground the nub flush and drilled the center.
Cut the screw to length, double nut in the "jig"
weld it
grind it almost flush, leave a slight dome.
sand blast, paint
New nuts and washers,
Install!
Spent about two hours making the first one, another hour making 3.
dont throw out those broken clips!
Thanks Linda!
Late side moulding clip repair
Moderators: notoptoy, S Allen, Solex68
-
pebbles
- Roadster Fanatic-Site Supporter
- Posts: 3931
- Joined: Thu Dec 16, 2010 12:00 am
- Location: Washington
Late side moulding clip repair
You do not have the required permissions to view the files attached to this post.
David
"When we were standing next to the motor while on the dyno, and the motor hit VVL, eyes went watery.."
"When we were standing next to the motor while on the dyno, and the motor hit VVL, eyes went watery.."
-
Datsun.David
- Site Supporter
- Posts: 1188
- Joined: Sat Sep 03, 2011 12:18 am
- Location: Calgary, Alberta, Canada
- Contact:
Re: Late side moulding clip repair
Lookin' Good Dave!
67.5 SRL311 #00050 - Silver - SU
67.5 SRL311 #00544 - Sora Blue SU
68 Roadster Race Car
69 SRL311
69 SRL311
72 PL510
74 260Z - Silver
67.5 SRL311 #00544 - Sora Blue SU
68 Roadster Race Car
69 SRL311
69 SRL311
72 PL510
74 260Z - Silver
-
Linda
- Fraternal Den Mother-RIP
- Posts: 7807
- Joined: Sat Nov 05, 2005 11:37 pm
- Location: Los Angeles
- Model: 1500/1600
- Year: High Windshield-68-70
Re: Late side moulding clip repair
Beyond my skill set, I don't weld....yet!
Good job!
Linda
Good job!
Linda
Sadly-Linda has passed away 2022. She was the 311's den mother and drove the first Rare-Parts ball joint project. RIP.
-
ladydriver
- Site Supporter
- Posts: 426
- Joined: Thu Apr 09, 2009 1:36 pm
- Location: Netherlands
- Model: 1500/1600
- Year: Low Windshield-64-67.5
- Contact:
Re: Late side moulding clip repair
I ordered new clips and they where a bit to big for my smaller strips.
Anyway i just scraped of some metal with a metalfile.
Put all clips in place, when all side strips where on the car, the one on the door was a bit higher than the others.
I removed the doorstrip, turned all the clips a 1/4 and filed off again, now this way: the bolt is out of the middle and higher to the top. I did all 5. put them back in place and the strip is now on the correct hight with the others.
Anyway i just scraped of some metal with a metalfile.
Put all clips in place, when all side strips where on the car, the one on the door was a bit higher than the others.
I removed the doorstrip, turned all the clips a 1/4 and filed off again, now this way: the bolt is out of the middle and higher to the top. I did all 5. put them back in place and the strip is now on the correct hight with the others.