I know this is the wrong place for this, but does anyone have any stock body parts from when you switched to fiberglass for racing that you can sell???? The only b-part in perfect shape is the hood... and both doors.... lucky me!!
http://www.cardomain.com/ride/779207/5 pic at bottom.... shows where the rust is. Also check out my radiator swap.
Body parts
Moderators: notoptoy, S Allen, Solex68
-
SLOroadster
- Roadsteraholic
- Posts: 5360
- Joined: Sun Dec 08, 2002 2:53 am
- Location: Napa Ca
The line of holes between the upper rear quarter pannel and the lower are for the stock stainless steel trim. The rocker pannels, well welcome to restoring a roadster, and the rear, there are drain holes in the bottom for the trunk. Break out the mig welder and go to town, thats what I had to do. Check out my car on cardomain, its the BRE one, (I think I changed the pic.)
Will
Will
Sorry, I find modern engine swaps revolting. Keep your G, R, or U series in your Roadster!
-
Import_sounds-of-mid-GA
Yeah, im trying to shave the sides of emblems and moldings.....and around the holes is good, its closer to the wheel. I also just ordered a top off eBay..... $175, just needs the twisties and posties. Will , I like the last pic on c-d, the whole car sitting low and all... why do you have the MSD under the hood? Us drag racers put it under the dash or inside the car! How does your cam do? does it idle good? did you change the rockers and (valve) springs?