What did you do TO or FOR your Datsun today?(Roadsters only)

[pletch]

adjusted the rear brakes.

[theunz]

Spent hours standing in front of the grinder using the wire wheel to clean and strip the paint off small parts and brackets that were to small to send to the blaster. Note to self, nothing is to small to send to blaster!

[Nissanman]

I can relate to that!
However, I think you are prudent in DIY, small bits tend to get lost at some "shops".
Just think, you can one day sit back and tell your grand kids, "I did that!".

[Kurt]

I made a phone call today. Okay it was yesterday. My prayers were answered concerning my guages. You know who you are and thank you!!!

[tjp]

I made a phone call today. Okay it was yesterday. My prayers were answered concerning my guages. You know who you are and thank you!!!

Phone call regarding sourcing guages or restoring gauges?

[tjp]

I pulled the tranny yoke off one of my 5 speeds (it was 2 degrees in my unheaed shop at the time) and took it and the driveshaft to get new U-joints and also balanced. One more step towards the stroker and 5 speed swap. getting closer getting closer

[Alvin]

quick detailed the cars before going to the track tomorrow!

[aka]

Pulled the body off the frame and started to rebuild the rusted out front mounts in the engine compartment.

[Tacomaboy 1]

Prep sand the dr. side rocker, found some crush and filler that I removed, Pulled out the dent's and am close to ready for filler tomorrow. Brought my new wheel bearing set to the the shop awaiting install with altima brk. package. Alvin..... you kill me.
Dust off the girls for the track. SSShhheezzzz. Dog. LOL. Good luck tomorrow. Were all pullin for ya!
Mike.

[Nissanman]

I hope the rocker panel is not religious, i.e. holy

[Alvin]

I made a phone call today. Okay it was yesterday. My prayers were answered concerning my guages. You know who you are and thank you!!!

I do know who I am
and you are welcome!

[Tacomaboy 1]

Got lucky on the rockers, I think. No rot, just caved in a bit at the rear. It pulled out pretty good so I'm feeling better. Thanks
Mike.

[pebbles]

quick detailed the cars before going to the track tomorrow!

Great pic Mr G

[garth]

I installed the driver's side latch and window regulator and fresh chromed front grille and head light trim. I spent a lot of time adjusting the hood-fender gaps. A 68 hood has issues fitting into a 69 body.

[CSP311]

Yesterday, busy making a replacement rubber flap to go inside part of my heater box...the flap to deflect heat to feet or 'screen. Also modifying the flap to be a better fit, and be smoother in operation.