Anyone know if the H20-II is usable as a stroker motor? The dimensions are all the same, But will the R16 head bolt on?
I have noticed that the H20 uses a head which looks almost identical to the R16, same valves, ports look the same, cast iron, upon first glance looks usable.
The H20-II however has smaller valves, so the head definately cannot be used. But the short-block? anyone know? Would be nice as it has a upgraded plastic/rubber rear main seal.
H20 / H20-II?
Moderators: notoptoy, S Allen, Solex68
-
Daryl Smith
- Roadster Fanatic-Site Supporter
- Posts: 1623
- Joined: Wed Sep 08, 2004 1:53 pm
- Location: Not Here
- Model: 1500/1600
- Year: Low Windshield-64-67.5
-
twinight
- Roadster Fanatic
- Posts: 85
- Joined: Fri May 07, 2004 9:57 am
- Location: Ladera Ranch, Ca
Re: H20 / H20-II?
I don't know about the head, but the crank journals are smaller than the H20 (1.77 vs 2.4).66wip wrote:Anyone know if the H20-II is usable as a stroker motor? The dimensions are all the same, But will the R16 head bolt on?
.