Well, I've managed a few hours in the garage the last couple of days.
the 4-2-1 header is installed along with the flex joint and O2 sensor. I have to cut a piece of 2" about 24" long and install that and the resonator to finish the exhaust.
The intake is installed and wired (injectors, air temp, and throttle position).
Adjusted the valves and did a compression check - 179# 183# 182# 182# one through four.
If I can get that exhaust piece in tomorrow night, the car will make the show on Sunday!
Hope you guys have fun at the autocross tomorrow while I'm working............
