Mid-west Contacts

So this has been around for a while. Started by Michael Carion originally. I thought it would be a good idea to start a fresh one here.

Moderators: notoptoy, S Allen, Solex68

Post Reply
User avatar
S Allen
Site Admin
Posts: 4530
Joined: Thu Dec 05, 2002 4:57 pm
Location: Knoxville, IA(Lake Redrock)Emory, TX
Model: 1500/1600
Year: Low Windshield-64-67.5
Contact:

Mid-west Contacts

Post by S Allen »

Any one passing through Iowa please feel free to contact me.

I have a shop, many tools, a lift and cold beer. A place to stay if you need it and food. I live right north of Lake Redrock in Marion County. We are about 30 miles south east of Des Moines.

Home Phone--six-four-one-226-five-1-seven-8
Cell--six-four-one-295-nine-8-three-2
Email addy--six-seven-datroad@three-one-one-s.org

Thanks.

Steve
66 Stroker-Going Orange
67 SRL311-00279-resto project
Stock '72 240Z-Blue
2002 Ford F250 7.3 Diesel 2WD Hauler
2008 Toyota FJ Cruiser
2009 Smart ForTwo Passion Coupe
2013 Fiat 500 Abarth
User avatar
JR311S
Roadster Nut
Posts: 44
Joined: Fri May 13, 2011 3:37 pm
Location: Akron, Ohio

North Coast contacts

Post by JR311S »

If your in northern Ohio you can contact me if you have a problem. I'm in Akron, Ohio just south of Cleveland (35 miles, 125 miles north of Columbus and 100 miles from Pittsburg) My shop is located at 1099 Evans Ave. Akron, Ohio. The Phone is 330-634-1011. I have some old 311 and Z parts. We are a chassis and alignment shop geared toward the trucking industry, but I have a car rack especially for the older cars. Jim Roark
Fossil Too (67.5 1600, Ser # SPL31111234)
Owned Datsuns: 72 240, 74 260Z, Solid, owned since 1985, 1972 1/2 620 p/u (built in 1977, sports a 331 inch Chevy, 4wd from a 66 K60 Nissan Patrol), a 95 4wd p/u and of course the 3 311's.
ct06033
Roadster Fanatic
Posts: 156
Joined: Mon Jul 06, 2015 12:10 am
Location: Denver, CO
Model: 1500/1600
Year: High Windshield-68-70

Re: Mid-west Contacts

Post by ct06033 »

I am near downtown in the Denver Area, no shop but there is a DYI center with a lift a few miles from my place. I use it to work on my roadster often. I also have many tools, parts, food, beer, and a couch. By virtue of my ownership, I also know where to go in town for almost anything that would need done or parts I don't have. Feel free to contact even if you just need ideas on where to eat. Cell: 941-713-2164 Sean McCarthy
2016 Audi TTS
2005 Honda S2000
1968 Datsun 1600
User avatar
Copterpilot
Site Supporter
Posts: 549
Joined: Tue Jun 05, 2012 1:50 pm
Location: Woodville, OH

Re: North Coast contacts

Post by Copterpilot »

JR311S wrote:If your in northern Ohio you can contact me if you have a problem. I'm in Akron, Ohio just south of Cleveland (35 miles, 125 miles north of Columbus and 100 miles from Pittsburg) My shop is located at 1099 Evans Ave. Akron, Ohio. The Phone is 330-634-1011. I have some old 311 and Z parts. We are a chassis and alignment shop geared toward the trucking industry, but I have a car rack especially for the older cars. Jim Roark
I may have to look you up sometime. I'm just southeast of Toledo. Are you any good with adjusting carbs?
White 1968 2000 Roadster
Gray 2003 VW Jetta TDI
Red 2005 Pontiac Vibe
2112 Toyota Highlander
Platinum White F150 Platinum Powerstroke
AS365 Dauphine
A109E Power
Post Reply