The Quick/Small/(Stupid?) Question Thread-take 2

[peeeter]

Post a picture of the loop/tab.

There should be a picture, its the loop on the outside, between the two rain gutters.

Wraps around the top frame hinge so your hair doesnt get pinched in the pivot, (60s hair .) .)

There's a pouch on the inside that warps the hinge, this loop is on the outside.

[Lorna c]

this in the circle ? never seen one . do u have it on both sides ?

[Lorna c]

Anyone know what this loop/tab is for on my soft top?

this in the red circle ? odd . but I'm not a long time rider of these yet . but I've never seen one in this spot before . do you have on both sides ?

[C.Costine]

That looks something like the top that was on my 67.5 there was a flap that I think that had a couple of snaps to hold it that partially enclosed the frame.

[peeeter]

this in the circle ? never seen one . do u have it on both sides ?

Yup! That's the piece, and yea, I have it on both sides.

That looks something like the top that was on my 67.5 there was a flap that I think that had a couple of snaps to hold it that partially enclosed the frame.

Mine is a 67.5 also, the loop has no snaps, its just a loop that is sewn there.

[spl310]

I've not seen one made quite like that. The picture didn't load for me the first time.

[Lorna c]

this in the circle ? never seen one . do u have it on both sides ?

Yup! That's the piece, and yea, I have it on both sides.

That looks something like the top that was on my 67.5 there was a flap that I think that had a couple of snaps to hold it that partially enclosed the frame.

Mine is a 67.5 also, the loop has no snaps, its just a loop that is sewn there.

haha well make something up for it's use is what I do .
note : don't do it in the engine though . not a good idea

[peeeter]

I've emailed Steve at acme auto to see what they say, will report back once I find out.

[Linda]

Looks like it should be on the inside. I think I would just want to cut it out
Linda

[mraitch]

Installing the engine on Eliza.

Seem to have misplaced some wiring since I cannot see where the temp sender attaches to the rest of the harness.

Any help would be appreciated.

[greydog]

The temp sender wire on our 69 1600 comes out of the main harness on the driver front near the washer pump wires. I think its a yellow wire.
Dan

[onsight512]

What's the fuel tank capacity? Mine is a '69 1600 if it matters.

thanks,
Chris

[Nissanman]

43L or 11US gallon

[onsight512]

43L or 11US gallon

Thanks!

[Lorna c]

Installing the engine on Eliza.

Seem to have misplaced some wiring since I cannot see where the temp sender attaches to the rest of the harness.

Any help would be appreciated.

is the motor in already ? . I'm still up to learn some more about this motor , if your still tinkering with it, can I watch and learn ?